smartctl 6.3 2014-07-26 r3976 [x86_64-linux-4.0.6-tuxonice] (local build) Copyright (C) 2002-14, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: HITACHI HTS541612J9SA00 3H Serial Number: SB2E41H7KR43TE LU WWN Device Id: 5 000cca 543f45626 Firmware Version: SB3IC7UP User Capacity: 120 034 123 776 bytes [120 GB] Sector Size: 512 bytes logical/physical Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ATA/ATAPI-7 T13/1532D revision 1 Local Time is: Wed Oct 14 17:34:20 2015 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 645) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 73) minutes. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000b 097 097 062 Pre-fail Always - 65541 2 Throughput_Performance 0x0005 108 108 040 Pre-fail Offline - 4430 3 Spin_Up_Time 0x0007 253 253 033 Pre-fail Always - 1 4 Start_Stop_Count 0x0012 095 095 000 Old_age Always - 8803 5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always - 0 7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0 8 Seek_Time_Performance 0x0005 134 134 040 Pre-fail Offline - 33 9 Power_On_Hours 0x0012 041 041 000 Old_age Always - 26233 10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 096 096 000 Old_age Always - 7401 191 G-Sense_Error_Rate 0x000a 100 100 000 Old_age Always - 0 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 2568487012 193 Load_Cycle_Count 0x0012 091 091 000 Old_age Always - 99955 194 Temperature_Celsius 0x0002 183 183 000 Old_age Always - 30 (Min/Max 12/44) 196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 201 197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always - 1 198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x000a 200 253 000 Old_age Always - 0 223 Load_Retry_Count 0x000a 100 100 000 Old_age Always - 0 SMART Error Log Version: 1 ATA Error Count: 8 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 8 occurred at disk power-on lifetime: 0 hours (0 days + 0 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 10 51 01 1f 6f f9 e0 Error: IDNF at LBA = 0x00f96f1f = 16346911 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 24 ff 01 1f 6f f9 e0 00 00:04:06.700 READ SECTOR(S) EXT 25 ff 01 1f 6f f9 e0 00 00:04:06.700 READ DMA EXT 34 ff 01 00 00 00 e0 00 00:04:04.500 WRITE SECTORS(S) EXT 25 ff 01 00 00 00 e0 00 00:04:04.500 READ DMA EXT 25 ff 01 c0 17 fa e0 00 00:04:04.500 READ DMA EXT Error 7 occurred at disk power-on lifetime: 0 hours (0 days + 0 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 10 51 01 1f 6f f9 e0 Error: IDNF 1 sectors at LBA = 0x00f96f1f = 16346911 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 25 ff 01 1f 6f f9 e0 00 00:04:06.700 READ DMA EXT 34 ff 01 00 00 00 e0 00 00:04:04.500 WRITE SECTORS(S) EXT 25 ff 01 00 00 00 e0 00 00:04:04.500 READ DMA EXT 25 ff 01 c0 17 fa e0 00 00:04:04.500 READ DMA EXT 25 ff 01 3f 00 00 e0 00 00:04:04.500 READ DMA EXT Error 6 occurred at disk power-on lifetime: 0 hours (0 days + 0 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 10 51 01 1f 6f f9 e0 Error: IDNF at LBA = 0x00f96f1f = 16346911 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 24 ff 01 1f 6f f9 e0 00 00:04:04.400 READ SECTOR(S) EXT 25 ff 01 1f 6f f9 e0 00 00:04:04.400 READ DMA EXT 34 ff 01 00 00 00 e0 00 00:04:02.300 WRITE SECTORS(S) EXT 35 ff 01 cf 17 fa e0 00 00:04:02.300 WRITE DMA EXT 35 ff 01 ce 17 fa e0 00 00:04:02.300 WRITE DMA EXT Error 5 occurred at disk power-on lifetime: 0 hours (0 days + 0 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 10 51 01 1f 6f f9 e0 Error: IDNF 1 sectors at LBA = 0x00f96f1f = 16346911 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 25 ff 01 1f 6f f9 e0 00 00:04:04.400 READ DMA EXT 34 ff 01 00 00 00 e0 00 00:04:02.300 WRITE SECTORS(S) EXT 35 ff 01 cf 17 fa e0 00 00:04:02.300 WRITE DMA EXT 35 ff 01 ce 17 fa e0 00 00:04:02.300 WRITE DMA EXT 35 ff 01 cd 17 fa e0 00 00:04:02.300 WRITE DMA EXT Error 4 occurred at disk power-on lifetime: 0 hours (0 days + 0 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 10 51 01 1f 6f f9 e0 Error: IDNF at LBA = 0x00f96f1f = 16346911 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 24 ff 01 1f 6f f9 e0 00 00:04:02.200 READ SECTOR(S) EXT 25 ff 01 1f 6f f9 e0 00 00:04:01.800 READ DMA EXT 34 ff 01 00 00 00 e0 00 00:03:59.700 WRITE SECTORS(S) EXT 35 ff 01 4e 00 00 e0 00 00:03:59.700 WRITE DMA EXT 35 ff 01 4d 00 00 e0 00 00:03:59.700 WRITE DMA EXT ^[mSMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Selective offline Completed without error 00% 26222 - # 2 Selective offline Completed: read failure 70% 26222 156992527 # 3 Selective offline Completed: read failure 70% 26221 124437758 # 4 Selective offline Aborted by host 90% 26220 - # 5 Extended offline Completed: read failure 10% 26220 81762969 # 6 Extended captive Interrupted (host reset) 90% 26218 - # 7 Extended captive Interrupted (host reset) 90% 26218 - # 8 Extended captive Interrupted (host reset) 90% 26209 - # 9 Extended offline Interrupted (host reset) 10% 26208 - #10 Short offline Completed without error 00% 26206 - #11 Extended offline Completed: read failure 70% 26203 58334175 #12 Extended offline Completed without error 00% 13983 - #13 Extended offline Completed without error 00% 13983 - #14 Extended offline Completed without error 00% 4761 - #15 Short offline Completed without error 00% 4760 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 156992527 183148559 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.