1. Spojazdnil som DSL ako vzdy v pohode len ked zadam sudo stdsl.sh stop , cize chcem vypnut internet tak mi vypise toto :
mato@masina:~$ sudo stdsl.sh stop
/usr/sbin/stdsl.sh: 20: stopadsl: not found
WTF ?
Po druhom zadani sudo stdsl.sh stop mi to vypise toto :
mato@masina:~$ sudo stdsl.sh stop
/usr/sbin/stdsl.sh: 20: stopadsl: not found
nas0: ERROR while getting interface flags: No such device
Usage:
kill pid ... Send SIGTERM to every process listed.
kill signal pid ... Send a signal to every process listed.
kill -s signal pid ... Send a signal to every process listed.
kill -l List all signal names.
kill -L List all signal names in a nice table.
kill -l signal Convert between signal numbers and names.
Ked zadam sudo stdsl.sh start , aby som internet opat zapol tak vsetko krasne napise :
mato@masina:~$ sudo stdsl.sh start
[sudo] password for mato:
br2684ctl[6143]: Interface "nas0" created sucessfully
br2684ctl[6143]: Communicating over ATM 0.1.32, encapsulation: LLC
br2684ctl[6143]: Interface configured
Plugin rp-pppoe.so loaded.
ale internet nefunguje , MUSIM VYTIAHNUT kabel z modemu, dat ho tam naspat a cakat minutu kym sa mi zosynchronizuje s linkou ( co je problem 2) a az potom funguje sudo stdsl.sh start , tak ako ma ...
Ked som mal opensuse, starsie ubuntu (myslim 6.10 alebo 7.04) tak to fungovalo....
2. Neda sa nejako zabezpecit, aby sa firmware nahraval rychlejsie do modemu? Dokonca este po nastartovani Ubuntu musim pockat asi 30s pokial sa mi zosychronizuje s linkou a az tak mozem zapnut internet. Skusal som aj davat firmware cxacru-fw-2.099.063.000 a aj cxacru-fw-2.099.093.000 , lenze vysledok je stale ten isty.
Dakujem za kazdu odpoved.
skus pastnut obsah stdsl.sh
s tym dalsim ti nepomozem
# ADSL connect for ST DSL
#2005.04.03 Ladislav Rado (lr (at) rsw (dot) sk)
case "$1" in
start)
modprobe br2684
modprobe ppp_generic
modprobe pppoe
br2684ctl -b -c 0 -a 0.1.32
ifconfig nas0 up
pppd call dsl-provider
;;
stop)
stopadsl
ifconfig nas0 down
ps h -o pid -C br2684ctl | xargs kill -s 9
;;
*)
echo "Usage `basename $0` {start|stop}"
esac
# ADSL connect for ST DSL #2005.04.03 Ladislav Rado (lr (at) rsw (dot) sk) case "$1" in start) modprobe br2684 modprobe ppp_generic modprobe pppoe br2684ctl -b -c 0 -a 0.1.32 ifconfig nas0 up pppd call dsl-provider ;; stop) stopadsl <----------------------------------------------------------------- ifconfig nas0 down ps h -o pid -C br2684ctl | xargs kill -s 9 ;; *) echo "Usage `basename $0` {start|stop}" esacnebolo v navode podla ktoreho si to rozbehaval pisane ze treba vytvorit (stiahnut, instalovat) aj stopadsl ???
http://www.vigor318.ic.cz/Ubuntu/index.html
naskor ppp alebo daco podobne