Intel PRO/Wireless 3945ABG

nejde mi tento net, prosim pomoc, s johnym burgerom ste mi skvele pomohli, pomoc s netom teraz prosim.
mam notebook a ani mi nenajde ziadne wifi siete, spinac mam na wifi zapnuty. mam ubuntu.

Pridať komentár

- Re: Intel PRO/Wireless 3945ABG 20.10.2008 | 22:11
  KiLo Debian stable Používateľ
  
  a pouzivas iwl3945, alebo ipw3945? a ktore prikazy si skusal ked vravis, ze ti nenajde siet?
  
  cat /dev/dsp > /dev/sda - ovladanie pocitaca hlasom
  
  Odpovedať
  - Re: Intel PRO/Wireless 3945ABG 20.10.2008 | 22:27
    bucic Návštevník
    
    no neinstaloval som zatial ziadny driver, ale mam stiahnuty ten ipw, neviem ho nainstalovat. v instrukciach pisu ze to mam nakopirovat do lib/firmware ale tam mam access denied, a na roota sa neviem dostat lebo sa nanho neda lognut. a ked dam pred prikaz sudo, a cp a strkam to do toho lib/firmware tak zmrzne terminal
    
    Odpovedať
  - Re: Intel PRO/Wireless 3945ABG 20.10.2008 | 22:38
    Laco Debian Lenny Používateľ
    
    no zalezi na tom, ake jadro pouziva....ak ma 2.6.24 a vyssie tak by mal mat ovladace v instalacii zahrnute, sem tam sa stane, ze chyba firmware, ten staci len stiahnut a nakopirovat....mal by si mrknut dmesg lahko zisti, co potrebuje
    
    Odpovedať
    - Re: Intel PRO/Wireless 3945ABG 20.10.2008 | 22:45
      bucic Návštevník
      
      [ 6.775175] wlan0: Initial auth_alg=0
      [ 6.775186] wlan0: authenticate with AP 00:11:09:bf:a8:79
      [ 6.776403] wlan0: RX authentication from 00:11:09:bf:a8:79 (alg=0 transaction=2 status=0)
      [ 6.776410] wlan0: authenticated
      [ 6.776414] wlan0: associate with AP 00:11:09:bf:a8:79
      [ 6.777946] wlan0: RX AssocResp from 00:11:09:bf:a8:79 (capab=0x431 status=0 aid=2)
      [ 6.777953] wlan0: failed to parse AssocResp
      [ 6.971248] wlan0: associate with AP 00:11:09:bf:a8:79
      [ 6.972697] wlan0: RX AssocResp from 00:11:09:bf:a8:79 (capab=0x431 status=0 aid=2)
      [ 6.972703] wlan0: failed to parse AssocResp
      [ 7.170903] wlan0: associate with AP 00:11:09:bf:a8:79
      [ 7.172354] wlan0: RX AssocResp from 00:11:09:bf:a8:79 (capab=0x431 status=0 aid=2)
      [ 7.172361] wlan0: failed to parse AssocResp
      [ 7.370553] wlan0: association with AP 00:11:09:bf:a8:79 timed out
      [ 9.932655] usb-storage: device scan complete
      [ 9.933641] scsi 4:0:0:0: Direct-Access PenDrive AVIXE 3.01 PQ: 0 ANSI: 2
      [ 9.936981] sd 4:0:0:0: [sdb] 1040832 512-byte hardware sectors (533 MB)
      [ 9.937851] sd 4:0:0:0: [sdb] Write Protect is off
      [ 9.937857] sd 4:0:0:0: [sdb] Mode Sense: 0b 00 00 08
      [ 9.937861] sd 4:0:0:0: [sdb] Assuming drive cache: write through
      [ 9.941344] sd 4:0:0:0: [sdb] 1040832 512-byte hardware sectors (533 MB)
      [ 9.942218] sd 4:0:0:0: [sdb] Write Protect is off
      [ 9.942224] sd 4:0:0:0: [sdb] Mode Sense: 0b 00 00 08
      [ 9.942228] sd 4:0:0:0: [sdb] Assuming drive cache: write through
      [ 9.942272] sdb: sdb1
      [ 9.955067] sd 4:0:0:0: [sdb] Attached SCSI removable disk
      [ 9.955136] sd 4:0:0:0: Attached scsi generic sg2 type 0
      [ 45.794324] sky2 eth0: disabling interface
      [ 45.810238] sky2 eth0: enabling interface
      [ 45.815061] ADDRCONF(NETDEV_UP): eth0: link is not ready
      [ 61.631012] usb 5-2: USB disconnect, address 5
      [ 61.631500] Buffer I/O error on device sdb1, logical block 301472
      [ 61.631509] lost page write due to I/O error on sdb1
      [ 61.631514] Buffer I/O error on device sdb1, logical block 301473
      [ 61.631518] lost page write due to I/O error on sdb1
      [ 143.960592] usb 5-2: new high speed USB device using ehci_hcd and address 7
      [ 144.102429] usb 5-2: configuration #1 chosen from 1 choice
      [ 144.103772] scsi5 : SCSI emulation for USB Mass Storage devices
      [ 144.104254] usb-storage: device found at 7
      [ 144.104259] usb-storage: waiting for device to settle before scanning
      [ 149.090523] usb-storage: device scan complete
      [ 149.091521] scsi 5:0:0:0: Direct-Access PenDrive AVIXE 3.01 PQ: 0 ANSI: 2
      [ 149.095734] sd 5:0:0:0: [sdb] 1040832 512-byte hardware sectors (533 MB)
      [ 149.096602] sd 5:0:0:0: [sdb] Write Protect is off
      [ 149.096609] sd 5:0:0:0: [sdb] Mode Sense: 0b 00 00 08
      [ 149.096613] sd 5:0:0:0: [sdb] Assuming drive cache: write through
      [ 149.100093] sd 5:0:0:0: [sdb] 1040832 512-byte hardware sectors (533 MB)
      [ 149.100967] sd 5:0:0:0: [sdb] Write Protect is off
      [ 149.100973] sd 5:0:0:0: [sdb] Mode Sense: 0b 00 00 08
      [ 149.100977] sd 5:0:0:0: [sdb] Assuming drive cache: write through
      [ 149.100982] sdb: sdb1
      [ 149.113818] sd 5:0:0:0: [sdb] Attached SCSI removable disk
      [ 149.113888] sd 5:0:0:0: Attached scsi generic sg2 type 0
      [ 2008.488517] iwl3945: Radio Frequency Kill Switch is On:
      [ 2008.488520] Kill switch must be turned off for wireless networking to work.
      
      polovicu som vymazal kvoli 5000 znakovemu limitu
      ta posledna veta je podozriva
      
      Odpovedať
      - Re: Intel PRO/Wireless 3945ABG 21.10.2008 | 02:15
        bucic Návštevník
        
        uz mi to ide, pouzil som ndiswrapper a stare drivre na windows. chvilu to neslo, potom som skusil restart len tak z <> a zrazu to ide ti vravim ty brdo no ty koky.
        
        Odpovedať
        
        Re: Intel PRO/Wireless 3945ABG 21.10.2008 | 11:21
        borg Arch, Debian jessie Administrátor
        
        a preco ked su nativne ovladace priamo pre linux a priamo od intelu?
        
        Odpovedať
        
        Re: Intel PRO/Wireless 3945ABG 21.10.2008 | 16:12
        bucic Návštevník
        
        ja to rozbehat nevim, je to divne, dal som tam ten firmware do lib/firmware/ ale asi to treba niekde este aktivovat v kerneli ci co, *.config, a nevim ani poradne ze kde to je.
        
        Odpovedať

Pridať komentár