Skusal som kluc niekolko krat sformatovat, zmazat particie (aj prenulovat cez dd) a stale nic.
Co sa s tym da robit?
Prikaldam este vypis c cp:
$ cp -v table0.start /media/disk/ `table0.start' -> `/media/disk/table0.start' cp: zapisuje sa `/media/disk/table0.start': Input/output errora vypis z dmesg
[104384.372041] usb 2-2: reset high speed USB device using ehci_hcd and address 11 [104387.678532] usb 2-2: USB disconnect, address 11 [104387.678857] sd 12:0:0:0: [sdf] Result: hostbyte=DID_ERROR driverbyte=DRIVER_OK,SUGGEST_OK [104387.678866] end_request: I/O error, dev sdf, sector 1255797 [104387.678873] Buffer I/O error on device sdf1, logical block 1255734 [104387.678875] lost page write due to I/O error on sdf1 [104387.678880] Buffer I/O error on device sdf1, logical block 1255735 [104387.678882] lost page write due to I/O error on sdf1 [104387.678884] Buffer I/O error on device sdf1, logical block 1255736 [104387.678886] lost page write due to I/O error on sdf1 [104387.678888] Buffer I/O error on device sdf1, logical block 1255737 [104387.678890] lost page write due to I/O error on sdf1 [104387.678893] Buffer I/O error on device sdf1, logical block 1255738 [104387.678895] lost page write due to I/O error on sdf1 [104387.678898] Buffer I/O error on device sdf1, logical block 1255739 [104387.678900] lost page write due to I/O error on sdf1 [104387.678903] Buffer I/O error on device sdf1, logical block 1255740 [104387.678904] lost page write due to I/O error on sdf1 [104387.678907] Buffer I/O error on device sdf1, logical block 1255741 [104387.678909] lost page write due to I/O error on sdf1 [104387.680925] sd 12:0:0:0: [sdf] Result: hostbyte=DID_ERROR driverbyte=DRIVER_OK,SUGGEST_OK [104387.680929] end_request: I/O error, dev sdf, sector 1330 [104387.680971] FAT: FAT read failed (blocknr 1267) [104387.690581] sd 12:0:0:0: [sdf] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK,SUGGEST_OK [104387.690589] end_request: I/O error, dev sdf, sector 1044813 [104387.692580] sd 12:0:0:0: [sdf] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK,SUGGEST_OK [104387.692585] end_request: I/O error, dev sdf, sector 1049869 [104387.692711] FAT: FAT read failed (blocknr 1267) [104387.745522] FAT: bread failed in fat_clusters_flush [104387.745800] FAT: unable to read inode block for updating (i_pos 125793) [104390.028038] usb 2-2: new high speed USB device using ehci_hcd and address 12 [104391.849127] usb 2-2: configuration #1 chosen from 1 choice [104391.851775] scsi13 : SCSI emulation for USB Mass Storage devices [104391.862535] usb-storage: device found at 12 [104391.862541] usb-storage: waiting for device to settle before scanning [104396.860188] usb-storage: device scan complete [104396.862277] scsi 13:0:0:0: Direct-Access USB 2.0 Flash Disk 0.00 PQ: 0 ANSI: 2 [104396.865136] sd 13:0:0:0: [sdf] 4030463 512-byte hardware sectors (2064 MB) [104396.866131] sd 13:0:0:0: [sdf] Write Protect is off [104396.866135] sd 13:0:0:0: [sdf] Mode Sense: 00 00 00 00 [104396.866137] sd 13:0:0:0: [sdf] Assuming drive cache: write through [104396.868633] sd 13:0:0:0: [sdf] 4030463 512-byte hardware sectors (2064 MB) [104396.870136] sd 13:0:0:0: [sdf] Write Protect is off [104396.870140] sd 13:0:0:0: [sdf] Mode Sense: 00 00 00 00 [104396.870142] sd 13:0:0:0: [sdf] Assuming drive cache: write through [104396.871282] sdf: sdf1 [104396.872599] sd 13:0:0:0: [sdf] Attached SCSI removable disk [104396.872860] sd 13:0:0:0: Attached scsi generic sg6 type 0
vypis z badblocks: Vyzera ze nema ziadne chyby. Bez chyb zbehlo aj fsck.