VEGAFB PROBLEM
Sekcia: Aplikácie & Desktop
27.10.2005 | 14:40
Dash
Návštevník
Bry den,
Ked sa system nabootuje tak mi vypise chybu:
vesafb: protecter mode interface info at c000:u5d0
vesafb: pmi: set display start = c00ca63e, set palette = c00ca6af
vesafb: hardware supports DDC2 transfers
vesafb: monitor limits: vf=0Hz, rf=0KHz, clk=0Mhz
vesafb: scrolling: redraw
Inastalujem jadro 2.6.12 a Gentoo 2005.1 ...
Netusim v com je problem...
Skusal som v lile nastavit vesa framebuffer console @ 640x480x256... Neslo.
Prosim o radu.
Dakujem
Pre pridávanie komentárov sa musíte prihlásiť.
-
-
Re: VEGAFB PROBLEM 23.10.2005 | 16:54peter golis Návštevníknabehne ten system v tom zobrazeni? aka je tam graficka karta?
-
Re: Re: VEGAFB PROBLEM 24.10.2005 | 13:31Dash Návštevníkjj, system nabehne v tom zobrazeni. A grafika ATI Mobility Radeon X300 64 MB...
-
Re: Re: Re: VEGAFB PROBLEM 24.10.2005 | 15:39peter golis Návštevníkak system nabehne v uvedenom zobrazeni tak sa nejedna o chybu ale o upozornenie. je s tym nejaky problem?
-
Re: Re: Re: Re: VEGAFB PROBLEM 24.10.2005 | 17:15Dash NávštevníkMozno o upozornenie. Ale. Disk vrci. Ako keby sa zapinal system. Taktiez je tam bodka ktora stale skace. No a na konec ked disk dovrci, tak bodka blika a nic sa nedeje... Zacnem pisat a ako keby som pisal do konzoly. Napisem napr. ls -l a bodka sa sprava tak ze sa posuva o jedno miesto. Ale ta chyba alebo upozornenie je tam stale, a to co pisem nieje vidiet...
-
Re: Re: Re: Re: Re: VEGAFB PROBLEM 24.10.2005 | 19:58peter golis Návštevníkako keby nemala dana graficka karta korektnu podporu frame bufferu v pouzitom jadre. ake je pouzite jadro? bol vykonany jeho upgrade? aka je to graficka karta? ako je zapojena na monitor? ako tu kartu identifikuje linux (lspci -v)? aky je to monitor? popripade, je potrebne pouzivat vesa frame buffer?
-
Re: Re: Re: Re: Re: Re: VEGAFB PROBLEM 25.10.2005 | 00:26Dash Návštevníkjadro 2.6.12 ziadny upgrade. je to notebook fujitsu siemens AMILO PRO 2120. som zaciatocnik s linuxom. takze nefim...sry
-
Re: Re: Re: Re: Re: Re: Re: VEGAFB PROBLEM 25.10.2005 | 00:49peter golis Návštevníkno, minimalne by bolo vhodne napisat prikaz: lspci -v a pozriet sa o aku kartu sa jedna. potom mozno budeme mudrejsi. predpokladam ze sa jedna o notebook bez pripojeneho externeho monitoru.
-
Re: Re: Re: Re: Re: Re: Re: Re: VEGAFB PROBLEM 25.10.2005 | 15:29Dash NávštevníkAno bez externeho pripojeneho monitoru. Skusal som nainstalovat predchadzajucu verizu gentoo 2005.0 a spravalo sa to podobne len s tym ze napisalo: mtrr: size and base must be multiples of 4 kiB Kedze sa nedostanem do systemu tak som to napisal ked nabootujem s cd. takze tu je to: 0000:00:00.0 Host bridge: VIA Technologies, Inc.: Unknown device 0259 Subsystem: VIA Technologies, Inc.: Unknown device 0259 Flags: bus master, 66Mhz, medium devsel, latency 8 Memory at d8000000 (32-bit, prefetchable) Capabilities: [80] AGP version 3.5 Capabilities: [50] Power Management version 2 0000:00:00.1 Host bridge: VIA Technologies, Inc.: Unknown device 1259 Flags: bus master, medium devsel, latency 0 0000:00:00.2 Host bridge: VIA Technologies, Inc.: Unknown device 2259 Flags: bus master, medium devsel, latency 0 0000:00:00.3 Host bridge: VIA Technologies, Inc.: Unknown device 3259 Flags: bus master, medium devsel, latency 0 0000:00:00.4 Host bridge: VIA Technologies, Inc.: Unknown device 4259 Flags: bus master, medium devsel, latency 0 0000:00:00.7 Host bridge: VIA Technologies, Inc.: Unknown device 7259 Flags: bus master, medium devsel, latency 0 0000:00:01.0 PCI bridge: VIA Technologies, Inc. VT8237 PCI Bridge (prog-if 00 [Normal decode]) Flags: bus master, 66Mhz, medium devsel, latency 0 Bus: primary=00, secondary=01, subordinate=01, sec-latency=0 Memory behind bridge: d1000000-d1ffffff Prefetchable memory behind bridge: f0000000-f3ffffff Secondary status: SERR Capabilities: [70] Power Management version 2 0000:00:06.0 Network controller: RaLink Ralink RT2500 802.11 Cardbus Reference Card (rev 01) Subsystem: RaLink: Unknown device 2560 Flags: slow devsel, IRQ 255 Memory at d0002000 (32-bit, non-prefetchable) [disabled] Capabilities: [40] Power Management version 2 0000:00:0c.0 CardBus bridge: ENE Technology Inc CB1410 Cardbus Controller (rev 01) Subsystem: Fujitsu Siemens Computer GmbH: Unknown device 1078 Flags: bus master, medium devsel, latency 168, IRQ 10 Memory at 0f000000 (32-bit, non-prefetchable) Bus: primary=00, secondary=02, subordinate=05, sec-latency=176 Memory window 0: 0f400000-0f7ff000 (prefetchable) Memory window 1: 0f800000-0fbff000 I/O window 0: 00004400-000044ff I/O window 1: 00004800-000048ff 16-bit legacy interface ports at 0001 0000:00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80) (prog-if 00 [UHCI]) Subsystem: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller Flags: bus master, medium devsel, latency 64, IRQ 7 I/O ports at 1020 [size=32] Capabilities: [80] Power Management version 2 0000:00:10.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80) (prog-if 00 [UHCI]) Subsystem: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller Flags: bus master, medium devsel, latency 64, IRQ 10 I/O ports at 1040 [size=32] Capabilities: [80] Power Management version 2 0000:00:10.3 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 82) (prog-if 20 [EHCI]) Subsystem: VIA Technologies, Inc. USB 2.0 Flags: bus master, medium devsel, latency 64, IRQ 11 Memory at d0000000 (32-bit, non-prefetchable) Capabilities: [80] Power Management version 2 0000:00:11.0 ISA bridge: VIA Technologies, Inc. VT8235 ISA Bridge Subsystem: VIA Technologies, Inc. VT8235 ISA Bridge Flags: bus master, stepping, medium devsel, latency 0 Capabilities: [c0] Power Management version 2 0000:00:11.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) (prog-if 8a [Master SecP PriP]) Subsystem: Fujitsu Siemens Computer GmbH: Unknown device 1078 Flags: bus master, medium devsel, latency 64, IRQ 7 I/O ports at 1000 [size=16] Capabilities: [c0] Power Management version 2 0000:00:11.5 Multimedia audio controller: VIA Technologies, Inc. VT8233/A/8235/8237 AC97 Audio Controller (rev 50) Subsystem: Fujitsu Siemens Computer GmbH: Unknown device 1078 Flags: medium devsel, IRQ 255 I/O ports at 1400 Capabilities: [c0] Power Management version 2 0000:00:11.6 Communication controller: VIA Technologies, Inc. AC'97 Modem Controller (rev 80) Subsystem: Fujitsu Siemens Computer GmbH: Unknown device 1078 Flags: medium devsel, IRQ 255 I/O ports at 1800 [disabled] Capabilities: [d0] Power Management version 2 0000:00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 74) Subsystem: Fujitsu Siemens Computer GmbH: Unknown device 1078 Flags: bus master, medium devsel, latency 64, IRQ 7 I/O ports at 1c00 Memory at d0000400 (32-bit, non-prefetchable) [size=256] Capabilities: [40] Power Management version 2 0000:01:00.0 VGA compatible controller: VIA Technologies, Inc. S3 Unichrome Pro VGA Adapter (rev 02) (prog-if 00 [VGA]) Subsystem: Fujitsu Siemens Computer GmbH: Unknown device 1078 Flags: 66Mhz, medium devsel, IRQ 7 Memory at f0000000 (32-bit, prefetchable) Memory at d1000000 (32-bit, non-prefetchable) [size=16M] Capabilities: [60] Power Management version 2 Capabilities: [70] AGP version 2.0
-
Re: Re: Re: Re: Re: Re: Re: Re: Re: VEGAFB PROBLEM 25.10.2005 | 20:08peter golis Návštevníknajlepsie by bolo ked sa startuje pocitac pridat parameter vga=normal. tym sa deaktivuje frame buffer ktory je imho na lcd uplne zbytocny aj ked s kombinaciou bootsplash vyzera pekne.
-
Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: VEGAFB PRO 25.10.2005 | 20:52Dash NávštevníkPardon za tu grafiku, splietol som sa... Este stale to neslape... aj po pridani VGA=normal...
-
Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: VEGAFB 25.10.2005 | 22:29peter golis Návštevníklinux je case sensitive. vga=normal a nie VGA=normal
-
Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: VE 26.10.2005 | 18:38Dash Návštevníkno aj ked som to zmenil na vga=normal to neslapalo... vyskusal som tu novu distro Arch linuxu... bo som videl na vic strankach ze je ako "sita" na moj notebook... skusil som to a vsetko slape hned po nainstalovani. dukujem. uz sa len pustit do manualu a pomocou pacmana instalit :) Dakujem
-
-
-
-
Re: Re: Re: Re: Re: Re: Re: Re: Re: VEGAFB PROBLEM 25.10.2005 | 20:10peter golis Návštevníkskoro by som zabudol, odkedy je s3 unichrome karta zvana ATI Mobility Radeon X300 64 MB?
-
-
Re: Re: Re: Re: Re: Re: Re: Re: VEGAFB PROBLEM 25.10.2005 | 15:43Dash NávštevníkNieco som nasiel na google.com, ale moc tomu nerozumem... :( Prosim pomoc http://www.ussg.iu.edu/hypermail/linux/kernel/0409.2/1771.html
-
Re: Re: Re: Re: Re: Re: Re: Re: Re: VEGAFB PROBLEM 27.10.2005 | 14:40peter golis Návštevníksi si naozaj isty ze tam mas radeon? nemyslim si ze toto: 0000:01:00.0 VGA compatible controller: VIA Technologies, Inc. S3 Unichrome Pro je graficka karta radeon od ATI. inac google poradil napriklad toto: http://ubuntuforums.org/showthread.php?t=76037 stacilo mu zadat linux "S3 Unichrome Pro"
-
-
Re: Re: Re: Re: Re: Re: Re: Re: VEGAFB PROBLEM 25.10.2005 | 15:45Dash Návštevníkhttp://developer.osdl.org/dev/robustmutexes/src/fusyn.hg/Documentation/mtrr.txt
-
-
-
-
-
-
-
-
